|
|
|
AD590JH Temperature Transducer, Two Wire, Current Output
General Description
The AD590 is an integrated-circuit temperature transducer which
produces an output current proportional to absolute temperature.
The device acts as a high impedance constant current regulator,
passing 1µA/ o K for supply voltages between +4V and +30V.
Laser trimming of the chip's thin film resistors is used to calibrate
the device to 298.2µA output at 298.2 o K (25 o C).
The AD590 should be used in any temperature-sensing application between -55 o
C to 150 o C in which conventional electrical temperature sensors are currently
employed. The inherent low cost of a monolithic integrated circuit combined with
the elimination of support circuitry makes the AD590 an attractive alternative
for many temperature measurement situations. Linearization circuitry, precision
voltage amplifiers, resistance measuring circuitry and cold junction compensation
are not needed in applying the AD590. In the simplest application, a resistor,
a power source and any voltmeter can be used to measure temperature.
In addition to temperature measurement, applications include temperature compensation
or correction of discrete components, and biasing proportional to absolute temperature.
The AD590 is particularly useful in remote sensing applications. The device is
insensitive to voltage drops over long lines due to its high-impedance current
output. Any well insulated twisted pair is sufficient for operation hundreds
of feet from the receiving circuitry. The output characteristics also make the
AD590 easy to multiplex: the current can be switched by a CMOS multiplexer or
the supply voltage can be switched by a logic gate output.
Features
- Linear Current Output 1µA/ o K
- Wide Temperature Range -55 o C to 150 o C
- Two-Terminal Device Voltage In/Current Out
- Wide Power Supply Range +4V to +30V
- Sensor Isolation From Case
- Low Cost
|
|
